Mono ASP440 with a Diesel Kubota RK70 Manual Start Motor 1800rpm Std Speed

NOV Mono® ASP Pump Range

The Mono Agricultural Surface Pump (ASP) is a water transfer pump and has been designed to pump potable water from rivers, dams, ponds or tanks to a desired location. The Mono ASP Surface pumping system is designed and manufactured in Australia. The Mono Pumps ASP has been design tested and proven in the field over a wide range of water pumping applications. It has been designed for maximum efficiency and reliability.There are two main configurations in the ASP Range:

1. THE MOTOROTOR unit consists of a pump and a direct coupled single phase electric motor, for easy installation and maintenance.
2. THE BARESHAFT unit is a pump which will need a drive connected to it via belts and pulleys. Mono supply complete motorised units with diesel, petrol or electric power plants.

SPECIFICATIONS

• Environmental
• Storage Temperature: -10 to 50 deg C
• Operating Temperature: -10 to 40 deg C
• IP Rating: IP55
• Humidity: 95% Max.
• Note: that if the ambient temperature exceeds 30 deg C it is recommended that the stator and motor be protected from direct sunlight with a well ventilated cover.


• Water Quality
• pH range 6 to 8.5
• Hardness Range 2000 mg/L
• Salt Concentration 500 ppm


• Rotor Selection - Water Temperature
• Rotor Standard 10 to 40 deg C
• Rotor Mk 3 40 to 70 deg C

MECHANICAL SPECIFICATION

• Inlet & Outlet
• Inlet - 1 1/2" Female BSP Internal Thread
• Outlet - 2" Female BSP Internal Thread


• Direction of Rotation
• Anticlockwise when viewed from the motor or bearing housing end.


• Materials (Excluding Motor)
• Pump Barrel: 304 Stainless Steel
• Stator: Natural rubber lining
• Rotor: 316 stainless steel
• Hard Chrome Plated
• Flexishaft: Titanium
• Mechanical seal: Carbon/Ceramic/Nitrile:
• Mechanical seal holder: 304 Stainless Steel
• Discharge Chamber: Cast Iron

MOTOR - MOTOROTOR ONLY

• Voltage 240 Volts AC +/- 5%
• Maximum Motor Starts per hour: 10
• Motor fitted with thermal cut out with manual reset.

MAXIMUM DESIGN PUMP PRESSURE

• ASP 310 - 600 kPa
• ASP 320 - 1200 kPa
• ASP 410 - 600 kPa
• ASP 420 - 1200 kPa (1000kpa on Motorotor)
• ASP 440 - 2400 kPa
• ASP 510 - 600 kPa
• ASP 520 - 1200 kPa
• ASP 610 - 600 kPa
• ASP 620 - 1200 kPa


• Note: Pumps are capable of much higher pressure if flow of pump is reduced. Running at over design pressure will reduce the life of the pump.

PERFORMANCE CURVES

Larger Image of Pump Performance table